This is a collection of 3D-printable parts which can be helpful for building and using a PurpleDrop.
Fixture to help with alignment of copper tape on glass edge.
The above, but for 75mm glass edges.
Simple stand for holding a raspberry pi v2 camera over the purpledrop.
You'll need some hardware to assemble: - Small screws/nuts for attaching the camera: M1.8, #1-72, or smaller. - Larger screws/nuts for setting the height: M3 or #6 screws work well here. Length around 18mm.
STL Files:
Useful for short term storage, or while working on a glass plate. It allows the plate to be set down while minimizing physical contact to only the corners.
There are several parts available for spin-coating top plates and dielectric films. They can be found in the spin_coating sub-directory.
Hinged box to store/transport 100x75mm dielectric frames. If creating these in batches, it's useful to have a safe place to store them to keep safe from accidental contact and dust.
