Base Klipper Config file for Klipper. Use at your own risk!! Please read the comments in the file, you will need to calibrate your hotend heater PID and E-steps
✔️ X Y Z E Steppers config
✔️ Heaters and Fans
⭕ (WIP) ABL using Z- (ZNP Glevel board - Strain Gauge Sensor) - 8bit AVR (STM8S003F3P6) + HX711 (Load cell amplifier), this board send out z-end digital signal at predetermined weight, triggered by probe contact
⭕ (WIP) Filament sensor
⭕ (WIP) Klipper's Pressure Adance calibrate
✔️ Klipper's Input Sharper. Mounts available, see below
I have pre-complied the firmware, you can download "ZNP_ROBIN_NANO_Klipper.bin" then remove _Klipper from the name and copy this file to your SD Card
If you would like to compile your own, please follow the instructions below:
Use the following config in make menuconfig
Once compiled, copy klipper.bin to an SD card (root folder) then rename it to ZNP_ROBIN_NANO.bin, insert it to your Neptune then switch on.
You can revert back to original firmware by placing the original firmware bin file to the SD card
I have also pre-complied the firmware, you can download "ZNP_ROBIN_NANO_Klipper.bin" then remove _Klipper from the name and copy this file to your SD Card
You will need to run your own PID calibration for the extruder heater, following the instructions here: https://www.klipper3d.org/Config_checks.html#calibrate-pid-settings or enter PID_CALIBRATE HEATER=extruder TARGET=170 into the console
Also extruder rotation_distance (I.e E-Steps): https://www.klipper3d.org/Rotation_Distance.html#calibrating-rotation_distance-on-extruders
- X Axis - Mount to X Carriage
- Y Axis - Mount to Bed
- -Clamp to hold board in place for Bed mount, sandwich the board in the middle
- Fusion 360 source file, it's a mess tho but I included it here if you like to make any changes
- Print at 0.2 layer height
- Reuse screws from the screen case