Merge pull request #191 from MartinHugh/readme_update

refer readme to vtx documentation

README.md

@@ -28,25 +28,10 @@ To download the latest firmware for your VTX, visit the [release page](https://g
 
 **Please do not arbitrarily modify the data in use in the EEPROM, that may make your VTX not work.**
 
-# Basic VTX hardware troubleshooting:
+# VTX troubleshooting:
 
-The Red LED is a simple indicator of power status and should be ON solid during normal operation.
-
-- If the Red LED is Off, dim, or flickering: Test power input to VTX is stable at expected voltage and within input voltage tolerance of VTX.
-
-The Blue LED provides these status indications:
-
-- flicker 3x after boot indicates MSP signaling is detected.
-- OFF = camera lost (check camera and cabling)
-- ON/OFF @ 1hz = heat protection
-- ON/OFF @ 4hz = 0MW pitt mode active
-- ON/OFF @ 2hz = 0.1mw pitt mode active
-- Flashes quickly 2 times per second = RF chip(dm6300) failure
-- ON solid = VTX operation normal
-
-If both Red and Blue LEDS are on solid but no video signal is detected by VRX:
-
-- use spectrum analyzer (available on some analog VRXs) to verify VTX RF output on correct channel.
-- use a PAT version of firmware for your specific VTX to verify RF output from VTX and test patern signal is received by VRX.
-
-The test pads on the VTX can also help verify some segments of the VTX cricut. eg: pad labeled 1v8 should be approximately 1.8 Volts.
+For troubleshooting the VTX, refer to
+[vtx troubleshooting](https://github.com/hd-zero/hdzero-vtx-docs/blob/main/docs/vtx_troubleshoot.md)
+and
+[vtx manual](https://github.com/hd-zero/hdzero-vtx-docs/blob/main/docs/vtx_user_manual.md)
+in the VTX documentation.