module power12 and 5

In_vign is an input, 12v when ignition is in start or run

V12_perm is battery, hot at all times

V12_Raw is power from the main relay, if so equipped.

5VP denotes a protected 5V output for powering sensors.

EN_5VP input is used to enable the 5VP voltage ("low" - off, "high" - on). To control this input, you can use the PWR_EN output from MM, or use a pull-up.

PG_5VP output can be used for diagnostics; "low" level indicates a short circuit in 5VP power bus. PG_5VP output can be left unconnected if diagnostics are not required.

TLS115D0EJXUMA1 is the best part number

(TLS115B0EJXUMA1 does not have status pin)

See also original power12