Update fdm_process_qidi_x3_common.json

little change

resources/profiles/Qidi/process/fdm_process_qidi_x3_common.json

@@ -18,7 +18,7 @@
  "compatible_printers_condition": "",
  "print_sequence": "by layer",
  "default_acceleration": "10000",
- "bridge_no_support": "1",
+ "bridge_no_support": "0",
  "draft_shield": "disabled",
  "elefant_foot_compensation": "0.15",
  "enable_arc_fitting": "0",
@@ -115,6 +115,7 @@
  "internal_solid_infill_pattern": "zig-zag",
  "initial_layer_travel_speed": "50%",
  "filter_out_gap_fill": "2",
+ "small_perimeter_threshold": "4",
  "notes": "If you want to use Orca's chamber temperature control feature, check that printer.cfg has added the following M191 macro.\nTo add it: go to Fluidd web interface--configuration, copy the following code to the top of the printer.cfg document, SAVE&RESATART \n\n[gcode_macro M191]\ngcode:\n {% set s = params.S|float %}\n {% if s == 0 %}\n # If target temperature is 0, do nothing\n M117 Chamber heating cancelled\n {% else %}\n SET_HEATER_TEMPERATURE HEATER=chamber_heater TARGET={s}\n # Orca: uncomment the following line if you want to use heat bed to assist chamber heating\n M140 S90\n TEMPERATURE_WAIT SENSOR=\"heater_generic chamber_heater\" MINIMUM={s-1} MAXIMUM={s+1}\n M117 Chamber at target temperature\n {% endif %}",
  "exclude_object": "1"
 }