firmware_configurations

Firmware Configurations

Firmware Configurations for Voron 3D printers, separated by firmware. Remember to update this README when uploading new firmware configurations!

Legacy printers

Configurations for legacy printers can be found here. If one of your configurations applies to a current generation Voron printer, contact the admins in Discord to have your mod moved to this folder.

Table structure

Update the following table with the information about your mod:

• Your name
• A link to your sub-folder
• A short description of your firmware config
• The printer compatibility. Use :heavy_check_mark: for ✔️,:x: for ❌ and :grey_question: for ❔

like so: | Creator | [Config Title](link) | Description | :x: | :x: | :x: | :x: |

---

Klipper

Creator	Config title	Description	V0	V1.8	V2.4	VSW	VT
clee	Fysetc S6 V2.1 for V0.1	Example configuration and board pin aliases for the Fysetc S6 V2.1 for V0.1	✔️	❌	❌	❌	❌
	Makerbase Eagle V1.0/Robin Nano V3.1	Example configuration and board pin aliases for the MKS Eagle/Robin Nano V3.1 for V0.1	✔️	❌	❌	❌	❌
jaeger	FYSETC Spider on V1.8	Example configuration and wiring diagram for a FYSETC Spider 1.1 board on the V1.8	❌	✔️	❌	❌	❌
MarcPot	Fysetc Spider Board Pins	Defines a set of [board_pins] aliases for use with the Fysetc Spider controller	✔️	✔️	✔️	✔️	❌
Mastah	Mandalaroseworks magnets avoidance	A klipper configuration for bed_mesh that allow the probe to avoid probing over magnets	❔	❔	✔️	❔	❔
Mellow	Fly-Super8 on V2.4	Example configuration and wiring diagram for a FLY-Super8 board on the V2.4	❌	❌	✔️	❌	❌
Mellow	Fly-Gemini on v0	Sample configuration and wiring diagram of Fly-Gemini Linux integrated motherboard in v0 and v0.1	✔️	❌	❌	❌	❌
revnull	BTT Octopus Board Pins	Defines a set of [board_pins] aliases for use with the BTT Octopus controller	❔	❔	✔️	❔	❌
RealDeuce	MKS Makerbase Monster8 v1.0_003	Configuration and instructions for installing an MKS Makerbase Monster8 board	❌	❌	✔️	❌	❌
TechnoPhreak	BTT SKR v2 for V2.4	Example configuration, wiring diagram and special instructions for the BTT SKR v2 controllers	❔	❔	✔️	❔
redelman	Fysetc Spider 2.2 for Voron Trident	Example configuration and special instructions for the Fysetc Spider 2.2 for VT	❌	❌	❌	❌	✔️

---

RepRapFirmware

Creator	Config title	Description	V0	V1.8	V2.4	VSW
DorjeDorf	Duet 3 Config	RRF 3.3 example config	❌	❌	✔️	❌
fulg	Duet 2 Config	RRF 2.05 example config	❌	❌	✔️	❌

---