To get the XN297L dump feature working on your module you must know:
- How to buid the firmware from the source code available on this GitHub. To do so follow this page: Compiling and programming the STM32 module.
- How to enable serial debug MULTI-Module Serial Debug.
Procedure to use the XN297L dump feature:
- Start the Multi module in serial debug mode with the Arduion IDE Serial Monitor open
- Select the protocol XN297DP, 63 or "Custom 63" to enable the XN297L Dump protocol
- This protocol parameters are:
- sub_protocol or type or the second number after "Custom 63" is used to set the transmission speed: 0=250Kbps, 1=1Mbps, 2=2Mbps and 3=Auto.
- Auto is the recommended mode since it gives many information like channels, timing, order as well as finding bytes meaning
- RX_num or Receiver number sets the address length 3, 4 or 5 bytes. Any other value will default to an address length of 5 bytes.
- option sets the RF channel number used to receive packets between 0..84 . A value of -1 will automatically scan all channels one by one. Any other value will default to the RF channel 0.
- sub_protocol or type or the second number after "Custom 63" is used to set the transmission speed: 0=250Kbps, 1=1Mbps, 2=2Mbps and 3=Auto.
Examples: TBC