Nach Stromausfall wird HMIP RF USB nicht mehr erkannt #2266
-
EDIT: Es läuft wieder alles ich habe in der boot config.txt auf 32 bit umgestellt(ist das eine nachhaltige Lösung?), dennoch kann ich mit sudo pivccu-info weiterhin keine Infos abrufen, was komisch für mich erscheint. Würde mich über jede Hilfe freuen! :) Nachdem mein Raspberry 4 unerwartet vom Strom getrennt wurde funktionierte plötzlich der Funksensor nicht mehr. Leider kann ich den Befehl sudo pivccu-info ebenfalls nicht mehr ausführen und bekomme folgende Fehlermeldung ausgespuckt: sudo: pivccu-info: command not found
|
Beta Was this translation helpful? Give feedback.
Replies: 1 comment 2 replies
-
Du bringst hier was Grundsätzliches durcheinander: RaspberryMatic und piVCCU sind zwei paar Schuhe bzw. zwei komplett voneinander unabhängige Lösungen eine CCU alternativ zur Hersteller Software von eQ3 zu betreiben. Bitte also erst einmal einlesen in die Materie und sich bewusst machen das du hier im RaspberryMatic Projekt Dinge über piVCCU diskutierst die hier aber nicht hingehören sondern eben ins piVCCU Projekt (wenn du piVCCU einsetzt!) Insofern ist das hier alles leider wohl fehl am Platz! |
Beta Was this translation helpful? Give feedback.
Du bringst hier was Grundsätzliches durcheinander: RaspberryMatic und piVCCU sind zwei paar Schuhe bzw. zwei komplett voneinander unabhängige Lösungen eine CCU alternativ zur Hersteller Software von eQ3 zu betreiben.
Bitte also erst einmal einlesen in die Materie und sich bewusst machen das du hier im RaspberryMatic Projekt Dinge über piVCCU diskutierst die hier aber nicht hingehören sondern eben ins piVCCU Projekt (wenn du piVCCU einsetzt!)
Insofern ist das hier alles leider wohl fehl am Platz!