You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
Hey there lovely script you made for using libcec with retropie! Bit hacky but hey works right?! I was able to connect my remote via your script but one thing that i noticed was that in my retroarch.conf your script detected a illegal 1. However this was not the case except for extra lines in the bottom; input_player1_analog_dpad_mode = "1"
I just uncommented the if section for checks for "1" but figured i'd post this here. Perhaps you could change the if section of your script. My python knowledge == "0" :)
Also, i changed buttons via evtest. Perhaps it would be handy for new users to point them in that direction should they need to change button layout with their remote controller. (I just reversed A and B).
The text was updated successfully, but these errors were encountered:
Hey there lovely script you made for using libcec with retropie! Bit hacky but hey works right?! I was able to connect my remote via your script but one thing that i noticed was that in my retroarch.conf your script detected a illegal 1. However this was not the case except for extra lines in the bottom;
input_player1_analog_dpad_mode = "1"
I just uncommented the if section for checks for "1" but figured i'd post this here. Perhaps you could change the if section of your script. My python knowledge == "0" :)
Also, i changed buttons via evtest. Perhaps it would be handy for new users to point them in that direction should they need to change button layout with their remote controller. (I just reversed A and B).
The text was updated successfully, but these errors were encountered: