You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
I had an issue with the Nozzle being far too low using the SOVOL SV08 Ocra Slicer Settings
PLA prints GREAT, no issues.
So I tried coping the PLA settings as PETG files in Orca Slicers with changes to reducing the speed and increasing the temperatures
BUT when I do this Slice then Upload for Printing the file still suggests that it is PLA in the filename
If I select PETG files in Orca Slicer it uploads and Prints with the PETG in the filename; but this has the Nozzle fare too low: DAMAGE the Build plate caused
reacted with thumbs up emoji reacted with thumbs down emoji reacted with laugh emoji reacted with hooray emoji reacted with confused emoji reacted with heart emoji reacted with rocket emoji reacted with eyes emoji
-
PETG on the SOVOL SV08 issues
I had an issue with the Nozzle being far too low using the SOVOL SV08 Ocra Slicer Settings
PLA prints GREAT, no issues.
So I tried coping the PLA settings as PETG files in Orca Slicers with changes to reducing the speed and increasing the temperatures
BUT when I do this Slice then Upload for Printing the file still suggests that it is PLA in the filename
If I select PETG files in Orca Slicer it uploads and Prints with the PETG in the filename; but this has the Nozzle fare too low: DAMAGE the Build plate caused
Beta Was this translation helpful? Give feedback.
All reactions