Meta-Gcode language? #6506
Rickthebig
started this conversation in
General
Replies: 1 comment 1 reply
-
These are Slicer dependent. See here for more https://help.prusa3d.com/article/macros_1775 Not sure if OrcaSlicer has such a page... |
Beta Was this translation helpful? Give feedback.
1 reply
Sign up for free
to join this conversation on GitHub.
Already have an account?
Sign in to comment
-
I often see expressions like this in start/end-gcode, layer change, etc.:
{ if layer_z < 3.6 }M140 T0 S[bed_temperature_initial_layer_single] { endif }
(this is only an example).
Thanks
Beta Was this translation helpful? Give feedback.
All reactions