You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
Inside the settings on the Support pane, I would like a setting under "Filament for supports" where if you have selected "Support/Raft Interface" as a separate filament, then a sub-menu comes up with the option to "Do not iron any surfaces using this filament".
The problem i have found is that if I need to use supports, be that PLA Support filament or PETG with PLA, then if I want my piece to look nice, and select ironing on it, then the filament for interface is also ironed as top surface, which makes it too smooth and it causes the subsequent filament to not have enough "grip".
So I would like the option to prevent ironing of support filament for all the interface layers.
That way you could print with support filament, and interfaces, and avoid failed prints because the subsequent filament did not slip of the support filament.
reacted with thumbs up emoji reacted with thumbs down emoji reacted with laugh emoji reacted with hooray emoji reacted with confused emoji reacted with heart emoji reacted with rocket emoji reacted with eyes emoji
-
Inside the settings on the Support pane, I would like a setting under "Filament for supports" where if you have selected "Support/Raft Interface" as a separate filament, then a sub-menu comes up with the option to "Do not iron any surfaces using this filament".
The problem i have found is that if I need to use supports, be that PLA Support filament or PETG with PLA, then if I want my piece to look nice, and select ironing on it, then the filament for interface is also ironed as top surface, which makes it too smooth and it causes the subsequent filament to not have enough "grip".
So I would like the option to prevent ironing of support filament for all the interface layers.
That way you could print with support filament, and interfaces, and avoid failed prints because the subsequent filament did not slip of the support filament.
Beta Was this translation helpful? Give feedback.
All reactions