You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
the klipper MCU in the ad5m is weak and klipper doesnt benefit from arcs like marlin does. it shouldnt be enabled by default on the flashforge ad5m it causes the MCU to get overloaded and freeze. also according to the start gcode and 'use relative E distances' checkbox checked this printer is using relative extrusion mode but doesnt have G92 E0 in the layer change gcode area. there have been reports of this causing print failures and i was under the impression it was required when using relative extrusion mode
reacted with thumbs up emoji reacted with thumbs down emoji reacted with laugh emoji reacted with hooray emoji reacted with confused emoji reacted with heart emoji reacted with rocket emoji reacted with eyes emoji
-
the klipper MCU in the ad5m is weak and klipper doesnt benefit from arcs like marlin does. it shouldnt be enabled by default on the flashforge ad5m it causes the MCU to get overloaded and freeze. also according to the start gcode and 'use relative E distances' checkbox checked this printer is using relative extrusion mode but doesnt have
G92 E0
in the layer change gcode area. there have been reports of this causing print failures and i was under the impression it was required when using relative extrusion modeBeta Was this translation helpful? Give feedback.
All reactions