You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
Hello, I have 4 anycubic kobra 2 max printers, I used anycubic slicer at first, but then I decided to switch to orka slicer, after a while they started printing in the air, where there shouldn't be anything instead of models, and at the end they completely stopped feeding plastic, and a crunch was heard in the extruder. The masters said that some components needed to be replaced (sorry, I don't remember the name)
Could the above problems be due to wrong settings in orka slicer?
reacted with thumbs up emoji reacted with thumbs down emoji reacted with laugh emoji reacted with hooray emoji reacted with confused emoji reacted with heart emoji reacted with rocket emoji reacted with eyes emoji
-
Hello, I have 4 anycubic kobra 2 max printers, I used anycubic slicer at first, but then I decided to switch to orka slicer, after a while they started printing in the air, where there shouldn't be anything instead of models, and at the end they completely stopped feeding plastic, and a crunch was heard in the extruder. The masters said that some components needed to be replaced (sorry, I don't remember the name)
Could the above problems be due to wrong settings in orka slicer?
Beta Was this translation helpful? Give feedback.
All reactions