You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
I need some help and ideas to identify the problem. I went thru the whole calibration process twice. I am not really experienced
in 3d printing, but I am getting there.
All the tests seems to be fine and in general the quality is good, there are just random blobs and holes in the print.
This is eSun PLA+ printed at 195°C.
I am adding current config, which I am also building as I did not find any pre-sets that would exist. Anycubic Kobra 2 Max - PLA.zip
reacted with thumbs up emoji reacted with thumbs down emoji reacted with laugh emoji reacted with hooray emoji reacted with confused emoji reacted with heart emoji reacted with rocket emoji reacted with eyes emoji
-
I need some help and ideas to identify the problem. I went thru the whole calibration process twice. I am not really experienced
in 3d printing, but I am getting there.
All the tests seems to be fine and in general the quality is good, there are just random blobs and holes in the print.
This is eSun PLA+ printed at 195°C.
I am adding current config, which I am also building as I did not find any pre-sets that would exist.
Anycubic Kobra 2 Max - PLA.zip
Beta Was this translation helpful? Give feedback.
All reactions