Replies: 4 comments 2 replies
-
Is this a possibility to add this?? |
Beta Was this translation helpful? Give feedback.
-
Once installed.... I wanted to run calibration but it says add G92 E0 to layer_gcode Please help |
Beta Was this translation helpful? Give feedback.
-
can we move out the droop? I used to have without drooping under Machine G-code, however, i can't input it under orcaslicer. anyhelp? thanks `M201 X500.00 Y500.00 Z100.00 E5000.00 ;Setup machine max acceleration ; Heat nozzle just enough to accurately home without drooping ; - Home - this is used with the strain gauge as a zero position for the Z-offset ; Now we know the positions we can move out of the way and happily droop at the side of the bed ; Now we know the positions we can move out of the way and happily droop at the side of the bed G0 Z25 ; Now wait for the temperatures to reach ; And we can now draw our purge line G92 E0 ; Reset Extruder |
Beta Was this translation helpful? Give feedback.
-
I have made profiles for Creality's CR-6 SE and Max printers to work with OrcaSlicer. I have updated the files to github here is the link if you would like to include them in a future release.
https://github.com/bhast2/CR-6Se-Max-OrcaSlicer-profile
Thank you
Beta Was this translation helpful? Give feedback.
All reactions