Dual extruder upgrade #44
Replies: 2 comments 3 replies
-
|
u/BambusBo on reddit did it :) he's running on klipper but I have compiled marlin firmware based on the stock that enables it also. |
Beta Was this translation helpful? Give feedback.
-
|
Will take look really interested in using pva for soluable supports to save on materials and easy removal of supports |
Beta Was this translation helpful? Give feedback.
-
|
That's problematic, without a proper purge you will almost definitely have pva contamination in you pla which can cause problems with your print. That type of thing is best done with an idex setup. |
Beta Was this translation helpful? Give feedback.
-
|
Best option may be to tinker the supports with the PLA for now. But if different pla colours definitely something to keep in mind |
Beta Was this translation helpful? Give feedback.
-
|
Multicolor is a lot of fun :) once you have your support distance figured out so you're getting decent support but easy separation you can do a lot more complex prints. Getting your bridging settings dialed in is helpful also so you don't need as many supports to start with. |
Beta Was this translation helpful? Give feedback.
-
Has anyone done a dual extruder on this machine yet?
Beta Was this translation helpful? Give feedback.
All reactions