Bed leveling

[Wolfy64]

It would be great to know how to fix the bed leveling and print a proper test. 🙇‍♂️

[NARUTOfzr]

#10
Try it first.

[Wolfy64]

I already tried #10. To be honest, I don't get how, loosening wheels will fix it, I did not notice any change. Maybe I did not do it the right way.
Will try again once my print is finished.
PS: I tried all FW version up to V1_1.0.4
PS2: I did all the process again and still can't make it, always the top right corner that is a bit off

[NARUTOfzr]

Are the three V wheels here tightened?
The three V-wheels on the other side, they turn easily when you print, right?

If the above conditions are normal, then please take a picture of the leveling value to see.

[Wolfy64]

All the conditions above are met, I did it one more time #10 and this time I also did #20 and everything still the same.
Here my latest leveling value and also my latest test:

[NARUTOfzr]

#7 I hope I can use their luck to help you solve this problem.

• &
  I hope you don't mind my repeating the story. Try to loosen or remove the right V wheel as shown below. (Tighten the other side properly)
  

[Wolfy64]

It works! 🙇
I loosened the right V wheel a bit more, when the doc said loosen I did not know that mean almost not tight at all.
Here is the result that is not perfect, but I think it should be good enough 🙂