Klipper wont Boot withouth PIS connectet

[7R0J4Ner]

Hello

I got the PIS installed and everything works fine.
But when i remove the PIS and reboot Klipper, it wont Boot and an Error shows "Not able to connect to MCU" or something.

Does the PIS now always have to remain connected to the printer, or did I simply do something wrong during setup?

Thank you

[DaVinci-10]

If you used the instructions. You just comment out the include in printer.cfg; and restart klipper. If your not permanently mounting it.

#include pis.cfg

[7R0J4Ner]

If you used the instructions.

Nowhere in this git is it written that this must be done, or am I wrong here?
Of course this will be noted somewhere in the Klipper Docs, but it would be helpful if the instructions were also complete here.

[DaVinci-10]

You can remove PIS after you get the [input_shaper] ...
https://github.com/FYSETC/FYSETC-PortableInputShaper/blob/5992485bd487227db958bc60abdc5699daa84f9c/README.md

[SrgntBallistic]

In the official Klipper IS docs that they link to in the readme it says to comment out the include line when the adxl is disconnected

https://www.klipper3d.org/Measuring_Resonances.html